On Fri, 16 Oct 2020 at 16:22, koti koti <kotisoftwaretest@gmail.com> wrote:
>
> Hi,
>
> I have connected  my Dragonboard-845 DUT to Lava Dispatcher (Dispatcher is
> "raspberry pi 4" SBC)
>
> Now I need to set up "Remote Power Control" and  "Set target into Program
> mode" .
>
> Please can someone let me know the required hardware list  like  "Remote
> PDU (Remote Power Distribution)" and  "Relays"  units purchase URL's in
> India for below requirement.
>
> 1. Power ON/Power OFF/reboot  the target from Lava Dispatcher.  ( Hope this
> functionality may be fully filled by the PDU. Can some let me know low cost
> PDU's URLs with 2 outlets)
> 2.  set target into Programing mode ( to flash the images)   (Is this
> functionality can be done by any relays? if yes, Please can someone let me
> know the available relays URL's in India)

you need to erase 'boot' partition. This way firmware always starts in
fastboot mode.

milosz

>
> Note:
> 1. I have found a couple of Relays URL's (
> https://www.robot-electronics.co.uk/products/relay-modules/ethernet-relay/eth008-8-x-16a-ethernet-relay.html)
> .
> * But these are not available in India.*
>
> Regards,
> Koti
>
>
> -=-=-=-=-=-=-=-=-=-=-=-
> Groups.io Links: You receive all messages sent to this group.
> View/Reply Online (#961): https://groups.io/g/kernelci/message/961
> Mute This Topic: https://groups.io/mt/77552735/1279106
> Group Owner: kernelci+owner@groups.io
> Unsubscribe: https://groups.io/g/kernelci/unsub [milosz.wasilewski@linaro.org]
> -=-=-=-=-=-=-=-=-=-=-=-
>
>