At the time of the original post, no it was not, but by the time of my update I did figure that much out and fixed that issue. However I still would get that problem from time to time, or (for unknown reasons) I would get a 404 error.
The problem I was facing afterwards (and still am) was instead that telnet (or LAVA, I am unsure which is the issue here) sends the commands over serial on top of one another, or on top of the output of a previous command. This sometimes (not always) causes them not to work, and thus requires intervention or the re-run of the test. Another issue is that just sometimes characters are missing, or completely rearranged within the submitted command. With some modifications of the file mentioned in my update (posted on 05/03), and some character delay option setting in the ser2net config file, I have increased the success rate from the initial 24% to 32%, which is still far from what I want.

I am unsure what needs to be done to get this working properly, and have been considering trying a multinode set up instead. I don't know if this would fix any of the issues though.

Best regards,
Michael
_______________________________________________
lava-users mailing list -- lava-users@lists.lavasoftware.org
To unsubscribe send an email to lava-users-leave@lists.lavasoftware.org
%(web_page_url)slistinfo%(cgiext)s/%(_internal_name)s